This is what a few hours of machining did to some 20 mm thick aluminium stock. I didn't have 20x20mm which would have saved a bunch of time (It would just be cut to length then drill, baby, drill), but at least this way they end up shinier, and I can anodize them should I so desire.
As you can see there is no M10 protruding the front (shown on the far left). The four pieces are all slightly different, but in essence they're just 20x20x52 mm with holes drilled 10, 20, 30 and 45mm from the bottom.
Also this is the 6mm laser cut acrylic to be assembled:
Ingen kommentarer:
Send en kommentar